World Library  
Flag as Inappropriate
Email this Article

Mitre box

Article Id: WHEBN0002594462
Reproduction Date:

Title: Mitre box  
Author: World Heritage Encyclopedia
Language: English
Subject: Backsaw, Woodworking, Glossary of woodworking, Mallet, Wood
Collection: Saws, Woodworking Hand Tools
Publisher: World Heritage Encyclopedia
Publication
Date:
 

Mitre box

A mitre box (US spelling, "miter box") is a wood working tool used to guide a hand saw to make precise mitre cuts in a board.

A home made manual miter sawing box.

The most common form of a mitre box is a 3-sided box which is open at the top and the ends. The box is made wide enough to accommodate the width of the boards to be cut. Slots are cut in the walls of the box at the precise angle at which the cut is to be made. These slots provide the guide for the saw to follow. Most commonly, the slots in the mitre box are cut at 45 degrees and 90 degrees.

The mitre saw combines the features of a mitre box with a backsaw.

In the past, mitre boxes were constructed mostly of wood. Some have had metal guides fitted to help prevent wear on the slots. Today, mitre boxes are also available in other materials such as moulded plastic and cast aluminium.

When carpenters used to make their own mitre boxes, it was common to use a mitre box until its guide slots became worn and then make a new one out of scrap timber. There is still a case to be made for making one today; for example, if an odd size (say, 175mm) cornice is to be fixed, then a custom mitre box with a bottom board that is 175mm wide would ensure that the cornice sits true while the cuts are being made to it. The three pieces of timber that form the mitre box are nailed together, and the top steadying pieces are fixed with smaller panel pins. The angles are marked (at any angle, not necessarily 45 degrees) and the guide slots are cut with the same saw that will be used for the rest of the cutting.

Use

In use, the board to be cut is placed in the box and the point at which the board is to be cut is lined up with the appropriate slot in the mitre box wall. A backsaw is the most common kind of saw used for this operation. The cut is started by placing the saw blade in the slot and drawing the saw back and forth. The slot guides the cut all the way through so that the result is a cut that is perpendicular to the face or edge of the board (depending upon the desired orientation of the cut) and at the appropriate angle. For precise work, a board cut in a mitre box might then be further adjusted on a shooting board.

References

This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 



Copyright © World Library Foundation. All rights reserved. eBooks from World Library are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.