World Library  
Flag as Inappropriate
Email this Article

F connector

Article Id: WHEBN0000535096
Reproduction Date:

Title: F connector  
Author: World Heritage Encyclopedia
Language: English
Subject: SMA connector, Home wiring, GR connector, RF connector, Technical standards in Hong Kong
Collection: Coaxial Connectors, Television Technology, Television Terminology
Publisher: World Heritage Encyclopedia
Publication
Date:
 

F connector


The F connector is a coaxial RF connector commonly used for "over the air" terrestrial television, cable television and universally for satellite television and cable modems, usually with RG-6/U cable or, in older installations, with RG-59/U cable.

The F Connector was invented by Eric E. Winston in the early 1950s while working for Jerrold Electronics on their development of cable television. [2]

In the 1970s it became commonplace on VHF television antenna connections in the United States, as coaxial cables replaced twin-lead, and later for UHF also.

The F connector is inexpensive, yet has good 75 Ω impedance match up to 1 GHz and has usable bandwidth up to several GHz. One reason for its low cost is that it commonly uses the solid conductor (center wire) of the specified types of coaxial cable as the pin of the male connector. Universally, Stainless Steel is used for all types of F connectors -- as opposed to Aluminum for Billing-Lee connectors.

This design is subject to the surface properties of the inner conductor (which must be solid wire) and is not corrosion resistant; hence waterproof versions are needed for outside use (for example, on aerials).

Corrosion resistance can be improved by coating all bare copper wires with silicone grease. The male connector body is typically crimped, or sometimes screwed, on to the exposed outer braid. Female F Type connectors have an external 3/8-32 UNEF thread ( diameter). Most male connectors have a matching internally threaded connecting ring, though push-on versions are also available.

Usage

The cable and satellite television entities (as a near standard practice) use compression fittings with F Type Connectors on customer premicies.

F Type Coax connectors are probably the most suitable for domestic terrestrial, cable, and satellite TV installations where the delivery of very high frequency information is required. Belling-Lee connectors (IEC 169-2) [used on European terrestrial receivers] are not well suited for long haul building delivery of frequencies above 500 MHz, because the standard was designed around tube receivers and Mediumwave (or Shortwave) antennas (but workarounds exist) [1]. Type F Connectors require slightly more care to properly install the Male connectors to the cable than with the Belling-Lee type, with the exception of compression or flex type connections.

Weatherproof & Flex F Connectors

Some component suppliers have in their catalog weatherproof (watertight) "F connectors". Tightness is achieved by inserting an O-ring of about 7 mm between the plug and the socket before tightening, making the union watertight.

Push-on (aka Flex) F Type connectors provide poorer shielding against microwave signals of high field strength. This leakage problem is more an artifact of bent or partly broken push on connectors, but is mostly not observed with compression connectors. Nearby television, FM radio, mobile & cordless phones, government radiolocation (54–1,002 MHz) [3] transmitters can potentially interfere with a CATV or DTH Satellite reception or operation if the Flex connector poorly installed.

See also

References

  • “F” Port (Female Indoor) Physical Dimensions, ANSI/SCTE 02 2006 (see www.scte.org).
  • International standard IEC 60169-24: Radio-frequency coaxial connectors with threaded coupling, typically for use in 75 Ω cable distribution systems (Type F). (non-free content)

External links

  • F Connector Installation Guide
  • Compression Tool for crimping
  1. ^
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
 
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
 
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.
 



Copyright © World Library Foundation. All rights reserved. eBooks from World Library are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.